Original file
Mazda 3 DensoL3CG-18881-E
An original (stock) flash read of the Denso control unit, fitted in Mazda 3, hardware number L3CG-18881-E, 1,024.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.
Technical data
About this file
Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.
How to use this file
- Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
- Open the file in your programmer, compare its numbers with your unit and check the checksum.
- Write it only to a Denso whose label carries the same hardware and software numbers.
Before you write Compare the numbers on your control unit with this file, hardware number L3CG-18881-E. A file written to a unit with other numbers can damage it. Not sure? Give your own read to the search above: it is compared by content.
Other reads of this pair
The same hardware and software numbers, read from other vehicles or at other times; each has its page.
Other pairs of Denso
| Hardware | Software | Vehicles |
|---|---|---|
| 31405743 | 31452623 | Volvo V60, Volvo XC60, Volvo V70 |
| L35HEH000 | Mazda 3, Mazda 3 MPS, Mazda 2 | |
| Toyota GT86 | Toyota GT86 | |
| 31405743CA | 32146196AA | Volvo S60, Volvo S70 / V70, Volvo XC60 |
| L3M7EN000 | Mazda 6, Mazda 6 MPS, Mazda 6 MZR DISI MPS | |
| AG9N-14C573-AB | Volvo V60, Volvo XC 60, Volvo S60 | |
| Denso | ||
| L37JEF000 | Mazda CX-7, Mazda XC-7, Mazda CX7 | |