Original file

BMW 5er Bosch EDC17CP45 O_7BUI-00000BA9-021 / N47D20T1-F10N47TL_EU5_MT

An original (stock) flash read of the Bosch EDC17CP45 control unit, fitted in BMW 5er, hardware number O_7BUI-00000BA9-021 and software number N47D20T1-F10N47TL_EU5_MT, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
BMW 5er2.0 diesel 218PS
Control unit
Bosch EDC17CP45
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
O_7BUI-00000BA9-021
Software number
N47D20T1-F10N47TL_EU5_MT

Technical data

Vehicle
BrandBMW
Car model5er
Engine2.0 diesel 218PS
Power218.0PS / 160.3kW
Control unit
Control unitBosch EDC17CP45
ECU makerBosch
Hardware numberO_7BUI-00000BA9-021
Software numberN47D20T1-F10N47TL_EU5_MT
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyea5c635c6e2ccc61
Identification read from the file
ECU nameEDC17CP45
Read typeCalibration only (data set)
Data set descriptionN47D20T1-F10N47TL_EU5_MT
Bosch project identifier (EPK)33/1/EDC17_CP45/11/P_731//VBUI///Offset in the file: 0x100B98

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP45 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number O_7BUI-00000BA9-021 and software number N47D20T1-F10N47TL_EU5_MT. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP45

Bosch EDC17CP45 original files

The Bosch EDC17CP45 unit page