Original file

Mercedes-Benz Bosch EDC17CP46 CR60-642LS-7CL0-Ch4_Q2-218CA-LS-EU5OP_4x4-ME08 / 1037543348

An original (stock) flash read of the Bosch EDC17CP46 control unit, fitted in Mercedes-Benz, hardware number CR60-642LS-7CL0-Ch4_Q2-218CA-LS-EU5OP_4x4-ME08 and software number 1037543348, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benzdiesel
Control unit
Bosch EDC17CP46
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR60-642LS-7CL0-Ch4_Q2-218CA-LS-EU5OP_4x4-ME08
Software number
1037543348
Software / calibration
6429029601

Technical data

Vehicle
BrandMercedes-Benz
Enginediesel
Control unit
Control unitBosch EDC17CP46
ECU makerBosch
Hardware numberCR60-642LS-7CL0-Ch4_Q2-218CA-LS-EU5OP_4x4-ME08
Software number1037543348
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key2f06a103d1692bb9
Identification read from the file
ECU nameEDC17CP46
Read typeCalibration only (data set)
Bosch part / software1037543348Offset in the file: 0x04001A
Software / calibration6429029601Offset in the file: 0x0770D7
Data set number6429032907Offset in the file: 0x0770E2
Bosch project identifier (EPK)46/1/EDC17CP46/1/P695//P_695_7CL0__CV130700///Offset in the file: 0x040BC0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP46 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR60-642LS-7CL0-Ch4_Q2-218CA-LS-EU5OP_4x4-ME08 and software number 1037543348. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP46

Bosch EDC17CP46 original files

The Bosch EDC17CP46 unit page