Original file

Mazda Denso SH7G-18881-F / GQ9NSH7GT4NA

An original (stock) flash read of the Denso control unit, fitted in Mazda, hardware number SH7G-18881-F and software number GQ9NSH7GT4NA, 2,015.25 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mazda6.4 diesel
Control unit
Denso
File size
2,015.25 KB
Contents
Flash
Hardware number
SH7G-18881-F
Software number
GQ9NSH7GT4NA

Technical data

Vehicle
BrandMazda
Engine6.4 diesel
Control unit
Control unitDenso
ECU makerDenso
Hardware numberSH7G-18881-F
Software numberGQ9NSH7GT4NA
File
File typeOriginal flash read
File size2,015.25 KB (2,063,616 bytes)
File key58709ecac9c24022

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Denso whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number SH7G-18881-F and software number GQ9NSH7GT4NA. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Denso

Denso original files