Original file

Mercedes-Benz Viano Bosch EDC17C66 CR41NFZ-651-FDS3-447M_LL-120kW-3OSL2S_D-EU5_OP-ME02 / 1037544344

An original (stock) flash read of the Bosch EDC17C66 control unit, fitted in Mercedes-Benz Viano, hardware number CR41NFZ-651-FDS3-447M_LL-120kW-3OSL2S_D-EU5_OP-ME02 and software number 1037544344, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Viano2.2 diesel 120KW
Control unit
Bosch EDC17C66
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR41NFZ-651-FDS3-447M_LL-120kW-3OSL2S_D-EU5_OP-ME02
Software number
1037544344
Software / calibration
6519020202

Technical data

Vehicle
BrandMercedes-Benz
Car modelViano
Engine2.2 diesel 120KW
Control unit
Control unitBosch EDC17C66
ECU makerBosch
Hardware numberCR41NFZ-651-FDS3-447M_LL-120kW-3OSL2S_D-EU5_OP-ME02
Software number1037544344
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key8b65e9936d9c6504
Identification read from the file
ECU nameEDC17C66
Read typeCalibration only (data set)
Bosch part / software1037544344Offset in the file: 0x02001A
Software / calibration6519020202Offset in the file: 0x08471F
Data set number6519039030Offset in the file: 0x08472A
Boot software6519041000Offset in the file: 0x084714
Bosch project identifier (EPK)45/1/EDC17C66/1/P695//P_695_FDS3__CV141100///Offset in the file: 0x020C80

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C66 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR41NFZ-651-FDS3-447M_LL-120kW-3OSL2S_D-EU5_OP-ME02 and software number 1037544344. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C66

Bosch EDC17C66 original files

The Bosch EDC17C66 unit page