Original file

Mercedes-Benz Sprinter Bosch EDC17CP99 CR60-BZO1-164XA_OES-155KW-BIN5-NOXTT3_CUKAT-ME18 / 1037516343

An original (stock) flash read of the Bosch EDC17CP99 control unit, fitted in Mercedes-Benz Sprinter, hardware number CR60-BZO1-164XA_OES-155KW-BIN5-NOXTT3_CUKAT-ME18 and software number 1037516343, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Sprinter210PS
Control unit
Bosch EDC17CP99
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
CR60-BZO1-164XA_OES-155KW-BIN5-NOXTT3_CUKAT-ME18
Software number
1037516343
Bosch part / software
10SW080374
Software / calibration
6429025004

Technical data

Vehicle
BrandMercedes-Benz
Car modelSprinter
Engine210PS
Displacement3.0
Power210.7PS / 155.0kW
Control unit
Control unitBosch EDC17CP99
ECU makerBosch
Hardware numberCR60-BZO1-164XA_OES-155KW-BIN5-NOXTT3_CUKAT-ME18
Software number1037516343
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key69e04ff5326495fb
Identification read from the file
ECU nameEDC17CP99
Read typeFull read (boot area included)
ProcessorTC1797
Bosch part / software10SW080374Offset in the file: 0x02001A
Software / calibration6429025004Offset in the file: 0x02022F
Data set number6429031520Offset in the file: 0x20120C
Boot software6429040200Offset in the file: 0x00FC51
Bosch project identifier (EPK)46/1/EDC17CP99/1/P695//P_695_BZO1__CV210800///Offset in the file: 0x057B24

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for the solutions it supports, such as DPF off, EGR off, lambda off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP99 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR60-BZO1-164XA_OES-155KW-BIN5-NOXTT3_CUKAT-ME18 and software number 1037516343. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP99

Bosch EDC17CP99 original files