Original file

Land Rover Velar DYNO CHIPTUNINGFILES Bosch MED17.9.9 L8A2-14C570-BFF / L560_J1_2P4T20AS250_C2_F_SS_1829BR2B_DTEV3_IS1_200

An original (stock) flash read of the Bosch MED17.9.9 control unit, fitted in Land Rover Velar DYNO CHIPTUNINGFILES, hardware number L8A2-14C570-BFF and software number L560_J1_2P4T20AS250_C2_F_SS_1829BR2B_DTEV3_IS1_200, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Land Rover Velar DYNO CHIPTUNINGFILES2.0 250HP
Control unit
Bosch MED17.9.9
Read type
Full read (boot area included)
File
2,048.00 KB · Flash
Hardware number
L8A2-14C570-BFF
Software number
L560_J1_2P4T20AS250_C2_F_SS_1829BR2B_DTEV3_IS1_200
Bosch part / software
10SW062633

Technical data

Vehicle
BrandLand Rover
Car modelVelar DYNO CHIPTUNINGFILES
Engine2.0 250HP
FuelDiesel
Control unit
Control unitBosch MED17.9.9
ECU makerBosch
Hardware numberL8A2-14C570-BFF
Software numberL560_J1_2P4T20AS250_C2_F_SS_1829BR2B_DTEV3_IS1_200
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key82c16ac328e054bf
Identification read from the file
ECU nameMED17.9.9
Read typeFull read (boot area included)
Bosch part / software10SW062633Offset in the file: 0x10001A
Bosch project identifier (EPK)51/1/MED17/190///D1799_P4SSFR_1829BR2B_DTEV3_IS1///Offset in the file: 0x0FFF08

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MED17.9.9 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number L8A2-14C570-BFF and software number L560_J1_2P4T20AS250_C2_F_SS_1829BR2B_DTEV3_IS1_200. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MED17.9.9

Bosch MED17.9.9 original files

The Bosch MED17.9.9 unit page