Original file

Jeep Commander Bosch EDC16CP31 CR4C-43W0-XH-160KW-V1-0706X070_DCA / 1037381282

An original (stock) flash read of the Bosch EDC16CP31 control unit, fitted in Jeep Commander, hardware number CR4C-43W0-XH-160KW-V1-0706X070_DCA and software number 1037381282, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Jeep Commander3.0 diesel 218PS
Control unit
Bosch EDC16CP31
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR4C-43W0-XH-160KW-V1-0706X070_DCA
Software number
1037381282

Technical data

Vehicle
BrandJeep
Car modelCommander
Engine3.0 diesel 218PS
Power218.0PS / 160.3kW
Control unit
Control unitBosch EDC16CP31
ECU makerBosch
Hardware numberCR4C-43W0-XH-160KW-V1-0706X070_DCA
Software number1037381282
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key02109417b5e0b93a
Identification read from the file
ECU nameEDC16CP31
Read typeCalibration only (data set)
Bosch part / software1037381282Offset in the file: 0x190010
Bosch project identifier (EPK)99/1/EDC16CP31/001/B209Offset in the file: 0x1906FB

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC16CP31 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR4C-43W0-XH-160KW-V1-0706X070_DCA and software number 1037381282. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC16CP31

Bosch EDC16CP31 original files

The Bosch EDC16CP31 unit page