Original file

Ford EcoSport Bosch EDC17C10 GN15-14C204-DHG / GN15-14C204-DHG

An original (stock) flash read of the Bosch EDC17C10 control unit, fitted in Ford EcoSport, hardware number GN15-14C204-DHG and software number GN15-14C204-DHG, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford EcoSport1.5 diesel · 90.0PS / 66.2kW
Control unit
Bosch EDC17C10
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
GN15-14C204-DHG
Software number
GN15-14C204-DHG
Bosch part / software
10SW032084

Technical data

Vehicle
BrandFord
Car modelEcoSport
Engine1.5 diesel
Power90.0PS / 66.2kW
Control unit
Control unitBosch EDC17C10
ECU makerBosch
Hardware numberGN15-14C204-DHG
Software numberGN15-14C204-DHG
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyd5b3904ff7bd4da1
Identification read from the file
ECU nameEDC17C10
Read typeCalibration only (data set)
ProcessorTC1767
Bosch part / software10SW032084Offset in the file: 0x08001A
Software / calibrationGN15-14C204-DHGOffset in the file: 0x07FF02
Bosch project identifier (EPK)36/1/EDC17C10/57/P1518//P1518B610///Offset in the file: 0x03CFC0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C10 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number GN15-14C204-DHG and software number GN15-14C204-DHG. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C10

Bosch EDC17C10 original files

The Bosch EDC17C10 unit page