Original file

Nissan Cabstar / NT400 Bosch EDC17C45 0281033718 / 10SW027682

An original (stock) flash read of the Bosch EDC17C45 control unit, fitted in Nissan Cabstar / NT400, hardware number 0281033718 and software number 10SW027682, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Nissan Cabstar / NT4003.0 diesel 130PS
Control unit
Bosch EDC17C45
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
0281033718
Software number
10SW027682
Vehicle maker's hardware number
23710LE15B
Software / calibration
P1533V150

Technical data

Vehicle
BrandNissan
Car modelCabstar / NT400
Engine3.0 diesel 130PS
Power130.0PS / 95.6kW
Control unit
Control unitBosch EDC17C45
ECU makerBosch
Hardware number0281033718
Software number10SW027682
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyf22f1bf34fa18c55
Identification read from the file
ECU nameEDC17C45
Read typeCalibration only (data set)
Bosch part / software10SW027682Offset in the file: 0x18001A
Vehicle maker's hardware number23710LE15BOffset in the file: 0x1D2C6E
Software / calibrationP1533V150Offset in the file: 0x180078
Bosch project identifier (EPK)38/1/EDC17_C45/20/P_1533//P1533V150///Offset in the file: 0x180078

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C45 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 0281033718 and software number 10SW027682. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C45

HardwareSoftwareVehicles
1037555577Renault Maxity
10SW027684Renault Maxity
01105555821037555582Renault Maxity
025A1037532496Nissan D-Cab 3.0 DCI
02768215331037555578Nissan NT400
02810312301037536841Nissan NT500
02810337181037555531Nissan Cabstar / NT400
23710LE15A10SW027681Nissan NT 400

Bosch EDC17C45 original files

The Bosch EDC17C45 unit page