Original file

Audi Q3 Bosch EDC17C64 04L907309AB / 10SW009926

An original (stock) flash read of the Bosch EDC17C64 control unit, fitted in Audi Q3, hardware number 04L907309AB and software number 10SW009926, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Audi Q32.0 diesel 183PS
Control unit
Bosch EDC17C64
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
04L907309AB
Software number
10SW009926
Software / calibration
04L906016FM

Technical data

Vehicle
BrandAudi
Car modelQ3
Engine2.0 diesel 183PS
Power183.5PS / 135.0kW
Control unit
Control unitBosch EDC17C64
ECU makerBosch
Hardware number04L907309AB
Software number10SW009926
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File keybb3df66e0b679175
Identification read from the file
ECU nameEDC17C64
Read typeFull read (boot area included)
Bosch part / software10SW009926Offset in the file: 0x02001A
Vehicle maker's hardware number04L907309ABOffset in the file: 0x334DBE
Software / calibration04L906016FM · version 3196Offset in the file: 0x334DD8
Internal build stringME(D)/EDC17 B_CB.02.03.00Offset in the file: 0x00FE50
Bosch project identifier (EPK)34/1/EDC17C64/5/P866//C866DG8PA///Offset in the file: 0x047B98

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C64 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 04L907309AB and software number 10SW009926. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C64

Bosch EDC17C64 original files

The Bosch EDC17C64 unit page