Original file

Mercedes-Benz Vito Bosch EDC17C66 CR41NFZ-651-FKS1-447A_RL-140kW-3OSL2S_D-EU6I_OPS-ME26 / 10SW064019

An original (stock) flash read of the Bosch EDC17C66 control unit, fitted in Mercedes-Benz Vito, hardware number CR41NFZ-651-FKS1-447A_RL-140kW-3OSL2S_D-EU6I_OPS-ME26 and software number 10SW064019, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Vito2.1 diesel 190PS
Control unit
Bosch EDC17C66
Read type
Calibration only (data set)
File
4,096.00 KB · Flash
Hardware number
CR41NFZ-651-FKS1-447A_RL-140kW-3OSL2S_D-EU6I_OPS-ME26
Software number
10SW064019
Software / calibration
6519022703

Technical data

Vehicle
BrandMercedes-Benz
Car modelVito
Engine2.1 diesel 190PS
Power190.3PS / 140.0kW
Control unit
Control unitBosch EDC17C66
ECU makerBosch
Hardware numberCR41NFZ-651-FKS1-447A_RL-140kW-3OSL2S_D-EU6I_OPS-ME26
Software number10SW064019
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key0aaabc88408e97c7
Identification read from the file
ECU nameEDC17C66
Read typeCalibration only (data set)
Bosch part / software10SW064019Offset in the file: 0x22001A
Software / calibration6519022703Offset in the file: 0x2893D7
Data set number6519032570Offset in the file: 0x2893E2
Boot software6519041400Offset in the file: 0x2893CC
Bosch project identifier (EPK)45/1/EDC17C66/1/P695//P_695_FKS1__CV180500///Offset in the file: 0x221140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C66 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR41NFZ-651-FKS1-447A_RL-140kW-3OSL2S_D-EU6I_OPS-ME26 and software number 10SW064019. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C66

Bosch EDC17C66 original files

The Bosch EDC17C66 unit page