Original file

Jeep Wrangler Bosch EDC17C69 MAJKHXE6J145CM524F / O40JTD40

An original (stock) flash read of the Bosch EDC17C69 control unit, fitted in Jeep Wrangler, hardware number MAJKHXE6J145CM524F and software number O40JTD40, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Jeep Wrangler2.8 diesel · 200.0PS / 147.1kW
Control unit
Bosch EDC17C69
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
MAJKHXE6J145CM524F
Software number
O40JTD40
Bosch part / software
10SW010404
Software / calibration
P_1404_EDC17C69_J145_1

Technical data

Vehicle
BrandJeep
Car modelWrangler
Engine2.8 diesel
Power200.0PS / 147.1kW
Control unit
Control unitBosch EDC17C69
ECU makerBosch
Hardware numberMAJKHXE6J145CM524F
Software numberO40JTD40
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key4e2f28a97eee5d35
Identification read from the file
ECU nameEDC17C69
Read typeFull read (boot area included)
ProcessorTC1793
Bosch part / software10SW010404Offset in the file: 0x02001A
Software / calibrationP_1404_EDC17C69_J145_1Offset in the file: 0x05F478
Internal build string11B.11.02.00RBOffset in the file: 0x00E580
Bosch project identifier (EPK)51/1/EDC17C69/1404/P1404//P_1404_EDC17C69_J145_1///Offset in the file: 0x05F478

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C69 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MAJKHXE6J145CM524F and software number O40JTD40. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C69

Bosch EDC17C69 original files

The Bosch EDC17C69 unit page