Original file

Ford Mondeo Bosch EDC17C70 FS7A-14C204-DYB / FS7A-14C204-DYB

An original (stock) flash read of the Bosch EDC17C70 control unit, fitted in Ford Mondeo, hardware number FS7A-14C204-DYB and software number FS7A-14C204-DYB, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford Mondeo1.5 diesel 120PS
Control unit
Bosch EDC17C70
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
FS7A-14C204-DYB
Software number
FS7A-14C204-DYB
Bosch part / software
10SW042399
Vehicle maker's hardware number
FS7A-12A650-DYB

Technical data

Vehicle
BrandFord
Car modelMondeo
Engine1.5 diesel 120PS
Control unit
Control unitBosch EDC17C70
ECU makerBosch
Hardware numberFS7A-14C204-DYB
Software numberFS7A-14C204-DYB
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyd5b2b7384c462089
Identification read from the file
ECU nameEDC17C70
Read typeCalibration only (data set)
ProcessorTC1793
Bosch part / software10SW042399Offset in the file: 0x08001A
Vehicle maker's hardware numberFS7A-12A650-DYBOffset in the file: 0x1799ED
Software / calibrationFS7A-14C204-DYBOffset in the file: 0x1799BB
Bosch project identifier (EPK)37/1/EDC17C70/57/P1084D//P1084D731///Offset in the file: 0x09A050

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C70 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number FS7A-14C204-DYB and software number FS7A-14C204-DYB. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C70

Bosch EDC17C70 original files

The Bosch EDC17C70 unit page