Original file

Nissan X-Trail Bosch EDC17C84 0122351251 / 10SW012235

An original (stock) flash read of the Bosch EDC17C84 control unit, fitted in Nissan X-Trail, hardware number 0122351251 and software number 10SW012235, 2,560.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Nissan X-Trail1.6 diesel · 130.0PS / 95.6kW
Control unit
Bosch EDC17C84
Read type
Calibration only (data set)
File
2,560.00 KB · Flash
Hardware number
0122351251
Software number
10SW012235
Vehicle maker's hardware number
237014CC6C
Software / calibration
r170B_720_

Technical data

Vehicle
BrandNissan
Car modelX-Trail
Engine1.6 diesel
Power130.0PS / 95.6kW
Control unit
Control unitBosch EDC17C84
ECU makerBosch
Hardware number0122351251
Software number10SW012235
File
File typeOriginal flash read
File size2,560.00 KB (2,621,440 bytes)
File key5b312bc2018fd9de
Identification read from the file
ECU nameEDC17C84
Read typeCalibration only (data set)
Bosch part / software10SW012235Offset in the file: 0x02001A
Vehicle maker's hardware number237014CC6COffset in the file: 0x223750
Software / calibrationr170B_720_Offset in the file: 0x02013C
Bosch project identifier (EPK)39/1/EDC17_C84/15/P_1251//r170B_720_///Offset in the file: 0x02013C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C84 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 0122351251 and software number 10SW012235. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C84

Bosch EDC17C84 original files

The Bosch EDC17C84 unit page