Original file

Nissan X-Trail Bosch EDC17C84 0173221251 / 10SW017322

An original (stock) flash read of the Bosch EDC17C84 control unit, fitted in Nissan X-Trail, hardware number 0173221251 and software number 10SW017322, 2,432.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Nissan X-Trail2.0 diesel · 180.0PS / 132.4kW
Control unit
Bosch EDC17C84
Read type
Calibration only (data set)
File
2,432.00 KB · Flash
Hardware number
0173221251
Software number
10SW017322
Vehicle maker's hardware number
237014BD1E
Software / calibration
r170B_A50_

Technical data

Vehicle
BrandNissan
Car modelX-Trail
Engine2.0 diesel
Power180.0PS / 132.4kW
Control unit
Control unitBosch EDC17C84
ECU makerBosch
Hardware number0173221251
Software number10SW017322
File
File typeOriginal flash read
File size2,432.00 KB (2,490,368 bytes)
File key5394f188d41ede86
Identification read from the file
ECU nameEDC17C84
Read typeCalibration only (data set)
Bosch part / software10SW017322Offset in the file: 0x00001A
Vehicle maker's hardware number237014BD1EOffset in the file: 0x20660E
Software / calibrationr170B_A50_Offset in the file: 0x00013C
Bosch project identifier (EPK)39/1/EDC17_C84/15/P_1251//r170B_A50_///Offset in the file: 0x00013C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17C84 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 0173221251 and software number 10SW017322. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17C84

Bosch EDC17C84 original files

The Bosch EDC17C84 unit page