Original file

Mercedes-Benz Sprinter Bosch EDC17CP10 CR6NFZ-642-6KN0-906A_NAG1-CHARGE4_3ZNW-140KW-NAFTA10_OPS-5.0T / 1037525436

An original (stock) flash read of the Bosch EDC17CP10 control unit, fitted in Mercedes-Benz Sprinter, hardware number CR6NFZ-642-6KN0-906A_NAG1-CHARGE4_3ZNW-140KW-NAFTA10_OPS-5.0T and software number 1037525436, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Sprinter2.1 diesel 213PS
Control unit
Bosch EDC17CP10
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR6NFZ-642-6KN0-906A_NAG1-CHARGE4_3ZNW-140KW-NAFTA10_OPS-5.0T
Software number
1037525436
Software / calibration
6429027601

Technical data

Vehicle
BrandMercedes-Benz
Car modelSprinter
Engine2.1 diesel 213PS
Power213.5PS / 157.0kW
Control unit
Control unitBosch EDC17CP10
ECU makerBosch
Hardware numberCR6NFZ-642-6KN0-906A_NAG1-CHARGE4_3ZNW-140KW-NAFTA10_OPS-5.0T
Software number1037525436
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key9fdc7d0f654ed923
Identification read from the file
ECU nameEDC17CP10
Read typeCalibration only (data set)
Bosch part / software1037525436Offset in the file: 0x18801A
Software / calibration6429027601Offset in the file: 0x185042
Data set number6429034204Offset in the file: 0x18504D
Bosch project identifier (EPK)45/1/EDC17CP10/1/P695//P_695_6KN0_CV121400///Offset in the file: 0x188BAC

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP10 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR6NFZ-642-6KN0-906A_NAG1-CHARGE4_3ZNW-140KW-NAFTA10_OPS-5.0T and software number 1037525436. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP10

Bosch EDC17CP10 original files

The Bosch EDC17CP10 unit page