Original file

Mercedes-Benz E220 Bosch EDC17CP10 CRD3-651-WMA4HD11 / 1037516352

An original (stock) flash read of the Bosch EDC17CP10 control unit, fitted in Mercedes-Benz E220, hardware number CRD3-651-WMA4HD11 and software number 1037516352, 6,144.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz E2202.2 diesel 170PS
Control unit
Bosch EDC17CP10
Read type
Full read (boot area included)
File
6,144.00 KB · Flash
Hardware number
CRD3-651-WMA4HD11
Software number
1037516352
Software / calibration
6519024803

Technical data

Vehicle
BrandMercedes-Benz
Car modelE220
Engine2.2 diesel 170PS
Power170.0PS / 125.0kW
Control unit
Control unitBosch EDC17CP10
ECU makerBosch
Hardware numberCRD3-651-WMA4HD11
Software number1037516352
File
File typeOriginal flash read
File size6,144.00 KB (6,291,456 bytes)
File key8f634ff46c84e5ec
Identification read from the file
ECU nameEDC17CP10
Read typeFull read (boot area included)
Bosch part / software1037516352Offset in the file: 0x58801A
Software / calibration6519024803Offset in the file: 0x100034
Data set number6519037665Offset in the file: 0x01C030
Boot software6519040001Offset in the file: 0x004154
Bosch project identifier (EPK)45/1/EDC17CP10/1/P695//P_695_6DN3_CV103800///Offset in the file: 0x588BAC

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP10 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CRD3-651-WMA4HD11 and software number 1037516352. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP10

Bosch EDC17CP10 original files

The Bosch EDC17CP10 unit page