Original file

Audi Bosch EDC17CP44 4G0907401E / 10SW036687

An original (stock) flash read of the Bosch EDC17CP44 control unit, fitted in Audi, hardware number 4G0907401E and software number 10SW036687, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Audi3.0 diesel 258PS
Control unit
Bosch EDC17CP44
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
4G0907401E
Software number
10SW036687
Software / calibration
8K5907401Q

Technical data

Vehicle
BrandAudi
Engine3.0 diesel 258PS
Power258.3PS / 190.0kW
Control unit
Control unitBosch EDC17CP44
ECU makerBosch
Hardware number4G0907401E
Software number10SW036687
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key9d49b4ec97ebe2f4
Identification read from the file
ECU nameEDC17CP44
Read typeFull read (boot area included)
Bosch part / software10SW036687Offset in the file: 0x02001A
Vehicle maker's hardware number4G0907401EOffset in the file: 0x328188
Software / calibration8K5907401Q · version 0011Offset in the file: 0x3281A2
Internal build stringME(D)/EDC17 B_CB.02.03.00Offset in the file: 0x00FE50
Bosch project identifier (EPK)37/1/EDC17_CP44/5/P1247//C1247CD6B///Offset in the file: 0x044384

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP44 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 4G0907401E and software number 10SW036687. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP44

Bosch EDC17CP44 original files

The Bosch EDC17CP44 unit page