Original file

Audi A6 3.0 TDI Bosch EDC17CP44 4G0907401E / 10SW049334 C985BAFT

An original (stock) flash read of the Bosch EDC17CP44 control unit, fitted in Audi A6 3.0 TDI, hardware number 4G0907401E and software number 10SW049334 C985BAFT, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Audi A6 3.0 TDI3.0 diesel 245.0PS / 180.2kW
Control unit
Bosch EDC17CP44
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
4G0907401E
Software number
10SW049334 C985BAFT
Bosch part / software
10SW049334
Software / calibration
4G0997401D

Technical data

Vehicle
BrandAudi
Car modelA6 3.0 TDI
Engine3.0 diesel 245.0PS / 180.2kW
Control unit
Control unitBosch EDC17CP44
ECU makerBosch
Hardware number4G0907401E
Software number10SW049334 C985BAFT
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File keyb3783c5a7d1211f6
Identification read from the file
ECU nameEDC17CP44
Read typeFull read (boot area included)
Bosch part / software10SW049334Offset in the file: 0x28301A
Vehicle maker's hardware number4G0907401EOffset in the file: 0x310E5E
Software / calibration4G0997401D · version 0003Offset in the file: 0x310E78
Bosch project identifier (EPK)35/1/EDC17_CP44/5/P985//C985CAFT///Offset in the file: 0x283A14

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP44 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 4G0907401E and software number 10SW049334 C985BAFT. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP44

Bosch EDC17CP44 original files

The Bosch EDC17CP44 unit page