Original file

Mercedes-Benz GLK220 Bosch EDC17CP46 CR42-651-CGW1-X204WA2X-100 / 040611

An original (stock) flash read of the Bosch EDC17CP46 control unit, fitted in Mercedes-Benz GLK220, hardware number CR42-651-CGW1-X204WA2X-100 and software number 040611, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLK2202.1 diesel 136PS
Control unit
Bosch EDC17CP46
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR42-651-CGW1-X204WA2X-100
Software number
040611
Bosch part / software
10SW040611
Software / calibration
6519023001

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLK220
Engine2.1 diesel 136PS
Control unit
Control unitBosch EDC17CP46
ECU makerBosch
Hardware numberCR42-651-CGW1-X204WA2X-100
Software number040611
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyceecb775d25a2a1e
Identification read from the file
ECU nameEDC17CP46
Read typeCalibration only (data set)
Bosch part / software10SW040611Offset in the file: 0x00001A
Software / calibration6519023001Offset in the file: 0x063041
Data set number6519036256Offset in the file: 0x06304C
Boot software6519040101Offset in the file: 0x063036
Bosch project identifier (EPK)46/1/EDC17CP46/1/P695//P_695_CGW1__CV123100///Offset in the file: 0x000BC0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP46 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR42-651-CGW1-X204WA2X-100 and software number 040611. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP46

Bosch EDC17CP46 original files

The Bosch EDC17CP46 unit page