Original file

Mercedes-Benz GLK200 Bosch EDC17CP46 CR42-651-CGW1-X204WM2X-125KW-CH4N-EU5OP-LL-EF-035_ME194900 / 10SW060741

An original (stock) flash read of the Bosch EDC17CP46 control unit, fitted in Mercedes-Benz GLK200, hardware number CR42-651-CGW1-X204WM2X-125KW-CH4N-EU5OP-LL-EF-035_ME194900 and software number 10SW060741, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLK2002.2 diesel 170PS
Control unit
Bosch EDC17CP46
Read type
Calibration only (data set)
File
4,096.00 KB · Flash
Hardware number
CR42-651-CGW1-X204WM2X-125KW-CH4N-EU5OP-LL-EF-035_ME194900
Software number
10SW060741
Software / calibration
6519023001

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLK200
Engine2.2 diesel 170PS
Power170.0PS / 125.0kW
Control unit
Control unitBosch EDC17CP46
ECU makerBosch
Hardware numberCR42-651-CGW1-X204WM2X-125KW-CH4N-EU5OP-LL-EF-035_ME194900
Software number10SW060741
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File keya61e1d3e3a60267b
Identification read from the file
ECU nameEDC17CP46
Read typeCalibration only (data set)
Bosch part / software10SW060741Offset in the file: 0x20001A
Software / calibration6519023001Offset in the file: 0x263041
Data set number6519033469Offset in the file: 0x26304C
Boot software6519040101Offset in the file: 0x263036
Bosch project identifier (EPK)46/1/EDC17CP46/1/P695//P_695_CGW1__CV123100///Offset in the file: 0x200BC0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP46 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR42-651-CGW1-X204WM2X-125KW-CH4N-EU5OP-LL-EF-035_ME194900 and software number 10SW060741. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP46

Bosch EDC17CP46 original files

The Bosch EDC17CP46 unit page