Original file

Mercedes-Benz GLK Bosch EDC17CP46 CR42-651-CXW0-X204WAX_MY15-200HP-CH4N-BIN5OPS-LL_CUKAT-EF-0 / 10SW078816

An original (stock) flash read of the Bosch EDC17CP46 control unit, fitted in Mercedes-Benz GLK, hardware number CR42-651-CXW0-X204WAX_MY15-200HP-CH4N-BIN5OPS-LL_CUKAT-EF-0 and software number 10SW078816, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLKdiesel
Control unit
Bosch EDC17CP46
Read type
Calibration only (data set)
File
4,096.00 KB · Flash
Hardware number
CR42-651-CXW0-X204WAX_MY15-200HP-CH4N-BIN5OPS-LL_CUKAT-EF-0
Software number
10SW078816
Software / calibration
6519022304

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLK
Enginediesel
Control unit
Control unitBosch EDC17CP46
ECU makerBosch
Hardware numberCR42-651-CXW0-X204WAX_MY15-200HP-CH4N-BIN5OPS-LL_CUKAT-EF-0
Software number10SW078816
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File key45b67d55507778cc
Identification read from the file
ECU nameEDC17CP46
Read typeCalibration only (data set)
Bosch part / software10SW078816Offset in the file: 0x20001A
Software / calibration6519022304Offset in the file: 0x25FD59
Data set number6519037076Offset in the file: 0x25FD64
Boot software6519040101Offset in the file: 0x25FD4E
Bosch project identifier (EPK)46/1/EDC17CP46/1/P695//P_695_CXW0__CV210700///Offset in the file: 0x201080

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP46 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR42-651-CXW0-X204WAX_MY15-200HP-CH4N-BIN5OPS-LL_CUKAT-EF-0 and software number 10SW078816. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP46

Bosch EDC17CP46 original files

The Bosch EDC17CP46 unit page