Original file

Mercedes-Benz ML Bosch EDC17CP46 CR60-642-9GLK-164XA_OES-155KW-EU6_NOXTT3-ME03 / 10SW087463

An original (stock) flash read of the Bosch EDC17CP46 control unit, fitted in Mercedes-Benz ML, hardware number CR60-642-9GLK-164XA_OES-155KW-EU6_NOXTT3-ME03 and software number 10SW087463, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz ML3.0 diesel 211PS
Control unit
Bosch EDC17CP46
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR60-642-9GLK-164XA_OES-155KW-EU6_NOXTT3-ME03
Software number
10SW087463
Software / calibration
6429024904

Technical data

Vehicle
BrandMercedes-Benz
Car modelML
Engine3.0 diesel 211PS
Power211.0PS / 155.2kW
Control unit
Control unitBosch EDC17CP46
ECU makerBosch
Hardware numberCR60-642-9GLK-164XA_OES-155KW-EU6_NOXTT3-ME03
Software number10SW087463
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key37b5fbaf08094a9f
Identification read from the file
ECU nameEDC17CP46
Read typeCalibration only (data set)
Bosch part / software10SW087463Offset in the file: 0x04001A
Software / calibration6429024904Offset in the file: 0x0277B1
Data set number6429039419Offset in the file: 0x0277BC
Bosch project identifier (EPK)46/1/EDC17CP46/1/P695//P_695_9GLK__CV210800///Offset in the file: 0x041080

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP46 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR60-642-9GLK-164XA_OES-155KW-EU6_NOXTT3-ME03 and software number 10SW087463. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP46

Bosch EDC17CP46 original files

The Bosch EDC17CP46 unit page