Original file

Mercedes-Benz Sprinter Bosch EDC17CP46 CR60NFZ-642-DDC1-906A_NAG2-140kW-EURO6_OPS-ME04_01 / 1037547167

An original (stock) flash read of the Bosch EDC17CP46 control unit, fitted in Mercedes-Benz Sprinter, hardware number CR60NFZ-642-DDC1-906A_NAG2-140kW-EURO6_OPS-ME04_01 and software number 1037547167, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Sprinter3.0 140KW
Control unit
Bosch EDC17CP46
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR60NFZ-642-DDC1-906A_NAG2-140kW-EURO6_OPS-ME04_01
Software number
1037547167
Software / calibration
6429022002

Technical data

Vehicle
BrandMercedes-Benz
Car modelSprinter
Engine3.0 140KW
FuelDiesel
Control unit
Control unitBosch EDC17CP46
ECU makerBosch
Hardware numberCR60NFZ-642-DDC1-906A_NAG2-140kW-EURO6_OPS-ME04_01
Software number1037547167
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyf88cacf65832fae6
Identification read from the file
ECU nameEDC17CP46
Read typeCalibration only (data set)
Bosch part / software1037547167Offset in the file: 0x14001A
Software / calibration6429022002Offset in the file: 0x0044BD
Data set number6429038607Offset in the file: 0x0044C8
Boot software6429040300Offset in the file: 0x0044B2
Bosch project identifier (EPK)46/1/EDC17CP46/1/P695//P_695_DDC1__CV134600///Offset in the file: 0x140BC0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP46 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR60NFZ-642-DDC1-906A_NAG2-140kW-EURO6_OPS-ME04_01 and software number 1037547167. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP46

Bosch EDC17CP46 original files

The Bosch EDC17CP46 unit page