Original file

Mercedes-Benz Sprinter Bosch EDC17CP46 WDB9066331S / 1037516354

An original (stock) flash read of the Bosch EDC17CP46 control unit, fitted in Mercedes-Benz Sprinter, hardware number WDB9066331S and software number 1037516354, 4,160.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Sprinter3.0 diesel 190PS
Control unit
Bosch EDC17CP46
Read type
Full read (boot area included)
File
4,160.00 KB · Flash
Hardware number
WDB9066331S
Software number
1037516354
Bosch part / software
1037555769
Software / calibration
6429022602

Technical data

Vehicle
BrandMercedes-Benz
Car modelSprinter
Engine3.0 diesel 190PS
Power190.3PS / 140.0kW
Control unit
Control unitBosch EDC17CP46
ECU makerBosch
Hardware numberWDB9066331S
Software number1037516354
File
File typeOriginal flash read
File size4,160.00 KB (4,259,840 bytes)
File key9bf1e292bc30ddd8
Identification read from the file
ECU nameEDC17CP46
Read typeFull read (boot area included)
ProcessorTC1797
Bosch part / software1037555769Offset in the file: 0x02001A
Software / calibration6429022602Offset in the file: 0x02022F
Data set number6429038008Offset in the file: 0x2044F0
Boot software6429040300Offset in the file: 0x00FC51
Bosch project identifier (EPK)46/1/EDC17CP46/1/P695//P_695_DEC1__CV145000///Offset in the file: 0x05AB78

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP46 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number WDB9066331S and software number 1037516354. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP46

Bosch EDC17CP46 original files

The Bosch EDC17CP46 unit page