Original file

Mercedes-Benz Sprinter Bosch EDC17CP57 0349461643 / 10SW034946

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz Sprinter, hardware number 0349461643 and software number 10SW034946, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Sprinter3.0 diesel 140KW
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
0349461643
Software number
10SW034946
Software / calibration
6429021303

Technical data

Vehicle
BrandMercedes-Benz
Car modelSprinter
Engine3.0 diesel 140KW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware number0349461643
Software number10SW034946
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keybd1e6c9b8133e27e
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW034946Offset in the file: 0x02001A
Software / calibration6429021303Offset in the file: 0x083507
Data set number6429039212Offset in the file: 0x083512
Boot software6429040500Offset in the file: 0x0834FC
Bosch project identifier (EPK)48/1/EDC17CP57/1/P1643//P_1643_44A0__CV174000///Offset in the file: 0x021538

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 0349461643 and software number 10SW034946. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

HardwareSoftwareVehicles
028103118410SW013266Mercedes-Benz GLS350
028103118410SW013298Mercedes-Benz GLE
028103161210SW026753Mercedes-Benz GLC
0281034413017688Mercedes-Benz Sprinter
034946164310SW034946164344A0Mercedes-Benz Sprinter
0370011652017475Mercedes-Benz X350
039119165210SW039119165252Q0Mercedes-Benz X-classe
039121165210SW039121Mercedes-Benz X350 SIMON !

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page