Original file

Mercedes-Benz GLE Bosch EDC17CP57 CR43-651-HDG1-166WA_AJ16_NAG3-150 / 10SW008728

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz GLE, hardware number CR43-651-HDG1-166WA_AJ16_NAG3-150 and software number 10SW008728, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLE2.2 diesel · 204.0PS / 150.0kW
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR43-651-HDG1-166WA_AJ16_NAG3-150
Software number
10SW008728
Software / calibration
6519022202

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLE
Engine2.2 diesel
Power204.0PS / 150.0kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR43-651-HDG1-166WA_AJ16_NAG3-150
Software number10SW008728
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyd3c75dd2892e85f7
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW008728Offset in the file: 0x02001A
Software / calibration6519022202Offset in the file: 0x07F9A3
Data set number6519035446Offset in the file: 0x07F9AE
Boot software6519040401Offset in the file: 0x07F998
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_HDG1__CV150200///Offset in the file: 0x021140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR43-651-HDG1-166WA_AJ16_NAG3-150 and software number 10SW008728. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page