Original file

Mercedes-Benz GLE250 Bosch EDC17CP57 CR43-651-HPG0-166WAX_AJ17_NAG3-150KW-CH4O-EU6OPS-LL-EF-020 / 10SW052636

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz GLE250, hardware number CR43-651-HPG0-166WAX_AJ17_NAG3-150KW-CH4O-EU6OPS-LL-EF-020 and software number 10SW052636, 896.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLE2502.2 diesel 204PS
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
896.00 KB · Flash
Hardware number
CR43-651-HPG0-166WAX_AJ17_NAG3-150KW-CH4O-EU6OPS-LL-EF-020
Software number
10SW052636
Software / calibration
6519022003

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLE250
Engine2.2 diesel 204PS
Power204.0PS / 150.0kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR43-651-HPG0-166WAX_AJ17_NAG3-150KW-CH4O-EU6OPS-LL-EF-020
Software number10SW052636
File
File typeOriginal flash read
File size896.00 KB (917,504 bytes)
File keya919af4ef8d514d1
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW052636Offset in the file: 0x00001A
Software / calibration6519022003Offset in the file: 0x061411
Data set number6519032565Offset in the file: 0x06141C
Boot software6519040401Offset in the file: 0x061406
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_HPG0__CV184300///Offset in the file: 0x001140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR43-651-HPG0-166WAX_AJ17_NAG3-150KW-CH4O-EU6OPS-LL-EF-020 and software number 10SW052636. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page