Original file

Mercedes-Benz GLE250D Bosch EDC17CP57 CR43-651-HQG0-166WAX_AJ15_NAG3-150KW-CH4O-EU6OPS-LL-EF-002 / 10SW063328

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz GLE250D, hardware number CR43-651-HQG0-166WAX_AJ15_NAG3-150KW-CH4O-EU6OPS-LL-EF-002 and software number 10SW063328, 896.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLE250D2.1 diesel 205PS
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
896.00 KB · Flash
Hardware number
CR43-651-HQG0-166WAX_AJ15_NAG3-150KW-CH4O-EU6OPS-LL-EF-002
Software number
10SW063328
Software / calibration
6519028303

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLE250D
Engine2.1 diesel 205PS
Power205PS / 150.8kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR43-651-HQG0-166WAX_AJ15_NAG3-150KW-CH4O-EU6OPS-LL-EF-002
Software number10SW063328
File
File typeOriginal flash read
File size896.00 KB (917,504 bytes)
File key9706b753c8b51183
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW063328Offset in the file: 0x00001A
Software / calibration6519028303Offset in the file: 0x061269
Data set number6519037369Offset in the file: 0x061274
Boot software6519040401Offset in the file: 0x06125E
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_HQG0__CV195000///Offset in the file: 0x001140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR43-651-HQG0-166WAX_AJ15_NAG3-150KW-CH4O-EU6OPS-LL-EF-002 and software number 10SW063328. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page