Original file

Mercedes-Benz Sprinter Bosch EDC17CP57 CR43NFZ-651-EJG1-906A-120 / 1037524978

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz Sprinter, hardware number CR43NFZ-651-EJG1-906A-120 and software number 1037524978, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Sprinter2.2 diesel · 163.0PS / 119.9kW
Control unit
Bosch EDC17CP57
Read type
Full read (boot area included)
File
4,096.00 KB · Flash
Hardware number
CR43NFZ-651-EJG1-906A-120
Software number
1037524978
Bosch part / software
1037555929
Software / calibration
6519029401

Technical data

Vehicle
BrandMercedes-Benz
Car modelSprinter
Engine2.2 diesel
Power163.0PS / 119.9kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR43NFZ-651-EJG1-906A-120
Software number1037524978
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File keyda169f460f59ce37
Identification read from the file
ECU nameEDC17CP57
Read typeFull read (boot area included)
ProcessorTC1793
Bosch part / software1037555929Offset in the file: 0x02001A
Software / calibration6519029401Offset in the file: 0x02022F
Data set number6519032732Offset in the file: 0x283D38
Boot software6519040401Offset in the file: 0x00FC4D
Internal build string001_2.2.00_CFG03Offset in the file: 0x00FC24
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_EJG1__CV150500///Offset in the file: 0x062CDC

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR43NFZ-651-EJG1-906A-120 and software number 1037524978. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page