Original file

Mercedes-Benz C300 Bosch EDC17CP57 CR61-DDB5-212SA-642LS-EU6OPS_4x2_3S_RED-ME08 / 008661

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz C300, hardware number CR61-DDB5-212SA-642LS-EU6OPS_4x2_3S_RED-ME08 and software number 008661, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz C3003.0 diesel · 231.0PS / 169.9kW
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR61-DDB5-212SA-642LS-EU6OPS_4x2_3S_RED-ME08
Software number
008661
Bosch part / software
10SW008661
Software / calibration
6429025402

Technical data

Vehicle
BrandMercedes-Benz
Car modelC300
Engine3.0 diesel
Power231.0PS / 169.9kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR61-DDB5-212SA-642LS-EU6OPS_4x2_3S_RED-ME08
Software number008661
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key2bdfdb2e44e4b4b8
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW008661Offset in the file: 0x02001A
Software / calibration6429025402Offset in the file: 0x078423
Data set number6429035210Offset in the file: 0x07842E
Boot software0009040200Offset in the file: 0x078418
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_DDB5__CV152600///Offset in the file: 0x020BC0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR61-DDB5-212SA-642LS-EU6OPS_4x2_3S_RED-ME08 and software number 008661. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page