Original file

Mercedes-Benz E Bosch EDC17CP57 CR61-DGB0-212SA-642LS-EU6OPS_4X2_3S_NOXTT3-ME14 / 10SW081062

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz E, hardware number CR61-DGB0-212SA-642LS-EU6OPS_4X2_3S_NOXTT3-ME14 and software number 10SW081062, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Ediesel
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
4,096.00 KB · Flash
Hardware number
CR61-DGB0-212SA-642LS-EU6OPS_4X2_3S_NOXTT3-ME14
Software number
10SW081062
Software / calibration
6429028603

Technical data

Vehicle
BrandMercedes-Benz
Car modelE
Enginediesel
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR61-DGB0-212SA-642LS-EU6OPS_4X2_3S_NOXTT3-ME14
Software number10SW081062
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
File keyd8deb1e93c21b8e2
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW081062Offset in the file: 0x22001A
Software / calibration6429028603Offset in the file: 0x27BC95
Data set number6429030019Offset in the file: 0x27BCA0
Boot software0009040200Offset in the file: 0x27BC8A
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_DGB0__CV195000///Offset in the file: 0x221080

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR61-DGB0-212SA-642LS-EU6OPS_4X2_3S_NOXTT3-ME14 and software number 10SW081062. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page