Original file

Mercedes-Benz E Coupe Bosch EDC17CP57 CR61-GDB2-207AA-642LS-EU6OPS_4x2_3S_NAG3-ME07 / 10SW004297

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz E Coupe, hardware number CR61-GDB2-207AA-642LS-EU6OPS_4x2_3S_NAG3-ME07 and software number 10SW004297, 896.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz E Coupediesel · 258PS / 189.8kW
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
896.00 KB · Flash
Hardware number
CR61-GDB2-207AA-642LS-EU6OPS_4x2_3S_NAG3-ME07
Software number
10SW004297
Software / calibration
6429025502

Technical data

Vehicle
BrandMercedes-Benz
Car modelE Coupe
Enginediesel
Displacement3.0
Power258PS / 189.8kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR61-GDB2-207AA-642LS-EU6OPS_4x2_3S_NAG3-ME07
Software number10SW004297
File
File typeOriginal flash read
File size896.00 KB (917,504 bytes)
File key85bdcaa6845d151c
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW004297Offset in the file: 0x00001A
Software / calibration6429025502Offset in the file: 0x05FFB3
Data set number6429035809Offset in the file: 0x05FFBE
Boot software0009040200Offset in the file: 0x05FFA8
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_GDB2__CV152500///Offset in the file: 0x001140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR61-GDB2-207AA-642LS-EU6OPS_4x2_3S_NAG3-ME07 and software number 10SW004297. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page