Original file

Mercedes-Benz Bosch EDC17CP57 CR61-GDB2-218XA-642LS-EU6OPS_4X4_3S_NAG3-ME11 / 10SW008698

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz, hardware number CR61-GDB2-218XA-642LS-EU6OPS_4X4_3S_NAG3-ME11 and software number 10SW008698, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-BenzOM642
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR61-GDB2-218XA-642LS-EU6OPS_4X4_3S_NAG3-ME11
Software number
10SW008698
Software / calibration
6429025502

Technical data

Vehicle
BrandMercedes-Benz
EngineOM642
FuelDiesel
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR61-GDB2-218XA-642LS-EU6OPS_4X4_3S_NAG3-ME11
Software number10SW008698
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keyadd39a8f596016f8
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW008698Offset in the file: 0x02001A
Software / calibration6429025502Offset in the file: 0x07FFB3
Data set number6429037410Offset in the file: 0x07FFBE
Boot software0009040200Offset in the file: 0x07FFA8
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_GDB2__CV152500///Offset in the file: 0x021140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR61-GDB2-218XA-642LS-EU6OPS_4X4_3S_NAG3-ME11 and software number 10SW008698. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page