Original file

Mercedes-Benz GLE 350CDI Bosch EDC17CP57 CR61-HDB2-292CA-642LS-EU6OPS_4x4_Romax_3S-ME15 / 013298

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz GLE 350CDI, hardware number CR61-HDB2-292CA-642LS-EU6OPS_4x4_Romax_3S-ME15 and software number 013298, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz GLE 350CDI3.0 diesel · 258.0PS / 189.8kW
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR61-HDB2-292CA-642LS-EU6OPS_4x4_Romax_3S-ME15
Software number
013298
Bosch part / software
10SW013298
Software / calibration
6429026102

Technical data

Vehicle
BrandMercedes-Benz
Car modelGLE 350CDI
Engine3.0 diesel
Power258.0PS / 189.8kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR61-HDB2-292CA-642LS-EU6OPS_4x4_Romax_3S-ME15
Software number013298
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File keybe36d80faa6d10d7
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW013298Offset in the file: 0x02001A
Software / calibration6429026102Offset in the file: 0x07D635
Data set number6429033111Offset in the file: 0x07D640
Boot software0009040200Offset in the file: 0x07D62A
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_HDB2__CV161400///Offset in the file: 0x021140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR61-HDB2-292CA-642LS-EU6OPS_4x4_Romax_3S-ME15 and software number 013298. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page