Original file

Mercedes-Benz G Bosch EDC17CP57 CR61-HDBB-GW463-642LS-180KW-EU6OPS-009_ME04 / 10SW033048

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz G, hardware number CR61-HDBB-GW463-642LS-180KW-EU6OPS-009_ME04 and software number 10SW033048, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz Gdiesel 245PS
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR61-HDBB-GW463-642LS-180KW-EU6OPS-009_ME04
Software number
10SW033048
Software / calibration
6429022503

Technical data

Vehicle
BrandMercedes-Benz
Car modelG
Enginediesel 245PS
Power245.0PS / 180.2kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR61-HDBB-GW463-642LS-180KW-EU6OPS-009_ME04
Software number10SW033048
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key5551bbac096b6306
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW033048Offset in the file: 0x02001A
Software / calibration6429022503Offset in the file: 0x07D879
Data set number6429034313Offset in the file: 0x07D884
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_HDBB__CV172100///Offset in the file: 0x021140

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR61-HDBB-GW463-642LS-180KW-EU6OPS-009_ME04 and software number 10SW033048. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page