Original file

Mercedes-Benz E Bosch EDC17CP57 CR61-KJE0-213WSA-642LS-EU6OPS_4 / 10SW050798

An original (stock) flash read of the Bosch EDC17CP57 control unit, fitted in Mercedes-Benz E, hardware number CR61-KJE0-213WSA-642LS-EU6OPS_4 and software number 10SW050798, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz E258PS
Control unit
Bosch EDC17CP57
Read type
Calibration only (data set)
File
2,048.00 KB · Flash
Hardware number
CR61-KJE0-213WSA-642LS-EU6OPS_4
Software number
10SW050798
Software / calibration
6429023803

Technical data

Vehicle
BrandMercedes-Benz
Car modelE
Engine258PS
FuelDiesel
Power258.0PS / 189.8kW
Control unit
Control unitBosch EDC17CP57
ECU makerBosch
Hardware numberCR61-KJE0-213WSA-642LS-EU6OPS_4
Software number10SW050798
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key9e20a8b7ebf7c626
Identification read from the file
ECU nameEDC17CP57
Read typeCalibration only (data set)
Bosch part / software10SW050798Offset in the file: 0x02001A
Software / calibration6429023803Offset in the file: 0x08179D
Data set number6429038814Offset in the file: 0x0817A8
Boot software0009040200Offset in the file: 0x081792
Bosch project identifier (EPK)46/1/EDC17CP57/1/P695//P_695_KJE0__CV185100///Offset in the file: 0x021538

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP57 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number CR61-KJE0-213WSA-642LS-EU6OPS_4 and software number 10SW050798. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP57

Bosch EDC17CP57 original files

The Bosch EDC17CP57 unit page