Original file

Ford F 150 3.0D V6 Bosch EDC17CP65 JL3A-12B684-BNA / 10SW062949

An original (stock) flash read of the Bosch EDC17CP65 control unit, fitted in Ford F 150 3.0D V6, hardware number JL3A-12B684-BNA and software number 10SW062949, 4,096.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford F 150 3.0D V63.0
Control unit
Bosch EDC17CP65
Read type
OBD read (no boot area)
File
4,096.00 KB · Flash
Hardware number
JL3A-12B684-BNA
Software number
10SW062949
Vehicle maker's hardware number
JL3A-12A650-BPB

Technical data

Vehicle
BrandFord
Car modelF 150 3.0D V6
Engine3.0
Control unit
Control unitBosch EDC17CP65
ECU makerBosch
Hardware numberJL3A-12B684-BNA
Software number10SW062949
File
File typeOriginal flash read
File size4,096.00 KB (4,194,304 bytes)
From the file nameFord 150 V6 2020y EDC17CP65
File key3f5cc6042e52d37f
Identification read from the file
ECU nameEDC17CP65
Read typeOBD read (no boot area)
ProcessorTC1793
Bosch part / software10SW062949Offset in the file: 0x02001A
Vehicle maker's hardware numberJL3A-12A650-BPBOffset in the file: 0x00FD30
Software / calibrationJL3A-12B684-BNAOffset in the file: 0x00FD00
Engine descriptionJL3A-14C204-EKDOffset in the file: 0x1FFF4B
Bosch project identifier (EPK)38/1/EDC17CP65/57/P1583//P1583_1030///Offset in the file: 0x1F43BB

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for the solutions it supports, such as DPF off, EGR off, lambda off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch EDC17CP65 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number JL3A-12B684-BNA and software number 10SW062949. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch EDC17CP65

Bosch EDC17CP65 original files

The Bosch EDC17CP65 unit page