Original file

Mercedes-Benz CLS350 Bosch MD1CP001 MRD1-17A-0M_9050D-213_238_257-WAX-OM656D29_210 / 10SW024842

An original (stock) flash read of the Bosch MD1CP001 control unit, fitted in Mercedes-Benz CLS350, hardware number MRD1-17A-0M_9050D-213_238_257-WAX-OM656D29_210 and software number 10SW024842, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz CLS3503.0 diesel 286PS
Control unit
Bosch MD1CP001
File size
8,192.00 KB
Contents
Flash
Hardware number
MRD1-17A-0M_9050D-213_238_257-WAX-OM656D29_210
Software number
10SW024842
Software / calibration
6549022800

Technical data

Vehicle
BrandMercedes-Benz
Car modelCLS350
Engine3.0 diesel 286PS
Power286.0PS / 210.4kW
Control unit
Control unitBosch MD1CP001
ECU makerBosch
Hardware numberMRD1-17A-0M_9050D-213_238_257-WAX-OM656D29_210
Software number10SW024842
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
From the file name749
File key9b0d1f9a757b979e
Identification read from the file
ECU nameMD1CP001
Bosch part / software10SW024842Offset in the file: 0x040144
Software / calibration6549022800Offset in the file: 0x4CA877
Data set number6569038502Offset in the file: 0x74BCDF
Bosch project identifier (EPK)46/1/MD1CP001/1/DA_MDG1D//DA_MDG1D_0M_9050D///Offset in the file: 0x4CA888

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MD1CP001 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRD1-17A-0M_9050D-213_238_257-WAX-OM656D29_210 and software number 10SW024842. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MD1CP001

Bosch MD1CP001 original files

The Bosch MD1CP001 unit page