Original file

Mercedes-Benz E300 Bosch MD1CP001 MRD1-18A-0M_B052D-213_238_257-WA-OM654D20_P290_143 / 10SW049370

An original (stock) flash read of the Bosch MD1CP001 control unit, fitted in Mercedes-Benz E300, hardware number MRD1-18A-0M_B052D-213_238_257-WA-OM654D20_P290_143 and software number 10SW049370, 7,680.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz E3002.0 petrol 306PS
Control unit
Bosch MD1CP001
File size
7,680.00 KB
Contents
Flash
Hardware number
MRD1-18A-0M_B052D-213_238_257-WA-OM654D20_P290_143
Software number
10SW049370

Technical data

Vehicle
BrandMercedes-Benz
Car modelE300
Engine2.0 petrol 306PS
FuelDiesel
Power306PS / 225.1kW
Control unit
Control unitBosch MD1CP001
ECU makerBosch
Hardware numberMRD1-18A-0M_B052D-213_238_257-WA-OM654D20_P290_143
Software number10SW049370
File
File typeOriginal flash read
File size7,680.00 KB (7,864,320 bytes)
File keyae939c7e5406b616
Identification read from the file
ECU nameMD1CP001
Bosch part / software10SW049370Offset in the file: 0x600144
Data set number6549034004Offset in the file: 0x71908F
Bosch project identifier (EPK)46/1/MD1CP001/1/DA_MDG1D//DA_MDG1D_0M_B052D///Offset in the file: 0x77FA7C

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MD1CP001 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRD1-18A-0M_B052D-213_238_257-WA-OM654D20_P290_143 and software number 10SW049370. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MD1CP001

Bosch MD1CP001 original files

The Bosch MD1CP001 unit page