Original file

Mercedes-Benz A220d Bosch MD1CP001 MRD1-18A-0M_B070D-MFA2_C / 6549025200

An original (stock) flash read of the Bosch MD1CP001 control unit, fitted in Mercedes-Benz A220d, hardware number MRD1-18A-0M_B070D-MFA2_C and software number 6549025200, 8,192.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz A220d2.0 diesel · 190.3PS / 140.0kW
Control unit
Bosch MD1CP001
File size
8,192.00 KB
Contents
Flash
Hardware number
MRD1-18A-0M_B070D-MFA2_C
Software number
6549025200
Bosch part / software
10SW039898

Technical data

Vehicle
BrandMercedes-Benz
Car modelA220d
Engine2.0 diesel
Power190.3PS / 140.0kW
Control unit
Control unitBosch MD1CP001
ECU makerBosch
Hardware numberMRD1-18A-0M_B070D-MFA2_C
Software number6549025200
File
File typeOriginal flash read
File size8,192.00 KB (8,388,608 bytes)
File keya278e5662a57d45f
Identification read from the file
ECU nameMD1CP001
Bosch part / software10SW039898Offset in the file: 0x040144
Software / calibration6549025200Offset in the file: 0x4E0137
Data set number6549031004Offset in the file: 0x75908F
Bosch project identifier (EPK)46/1/MD1CP001/1/DA_MDG1D//DA_MDG1D_0M_B070D///Offset in the file: 0x4E0148

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MD1CP001 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRD1-18A-0M_B070D-MFA2_C and software number 6549025200. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MD1CP001

Bosch MD1CP001 original files

The Bosch MD1CP001 unit page