Original file

Mercedes-Benz Sprinter Bosch MD1CP001 MRD1NFZ-19B-0V_E080D-907A-125 / 6549017600

An original (stock) flash read of the Bosch MD1CP001 control unit, fitted in Mercedes-Benz Sprinter, hardware number MRD1NFZ-19B-0V_E080D-907A-125 and software number 6549017600, 7,936.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Mercedes-Benz SprinterOM654 · 170.0PS / 125.0kW
Control unit
Bosch MD1CP001
File size
7,936.00 KB
Contents
Flash
Hardware number
MRD1NFZ-19B-0V_E080D-907A-125
Software number
6549017600
Bosch part / software
10SW065457
Software / calibration
6549028603

Technical data

Vehicle
BrandMercedes-Benz
Car modelSprinter
EngineOM654
FuelDiesel
Displacement2.0
Power170.0PS / 125.0kW
Control unit
Control unitBosch MD1CP001
ECU makerBosch
Hardware numberMRD1NFZ-19B-0V_E080D-907A-125
Software number6549017600
File
File typeOriginal flash read
File size7,936.00 KB (8,126,464 bytes)
File key593fc7d92aeafb14
Identification read from the file
ECU nameMD1CP001
Bosch part / software10SW065457Offset in the file: 0x040144
Software / calibration6549028603Offset in the file: 0x51C7DF
Data set number6549030108Offset in the file: 0x6F5AF7
Bosch project identifier (EPK)46/1/MD1CP001/1/DA_MDG1D//DA_MDG1D_0V_E080D///Offset in the file: 0x51C7F0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MD1CP001 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MRD1NFZ-19B-0V_E080D-907A-125 and software number 6549017600. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MD1CP001

Bosch MD1CP001 original files

The Bosch MD1CP001 unit page