Original file

BMW X5 Bosch MD1CP002 O_8KWN0-00004E7B-006 / 10SW048033

An original (stock) flash read of the Bosch MD1CP002 control unit, fitted in BMW X5, hardware number O_8KWN0-00004E7B-006 and software number 10SW048033, 7,936.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
BMW X53.0 diesel 399PS
Control unit
Bosch MD1CP002
File size
7,936.00 KB
Contents
Flash
Hardware number
O_8KWN0-00004E7B-006
Software number
10SW048033

Technical data

Vehicle
BrandBMW
Car modelX5
Engine3.0 diesel 399PS
Power399.7PS / 294.0kW
Control unit
Control unitBosch MD1CP002
ECU makerBosch
Hardware numberO_8KWN0-00004E7B-006
Software number10SW048033
File
File typeOriginal flash read
File size7,936.00 KB (8,126,464 bytes)
File key29cb80eaa40aab0b
Identification read from the file
ECU nameMD1CP002
Bosch part / software10SW048033Offset in the file: 0x000164
Data set descriptionB57D30S0-G05B57S0_AWR1_AT
Bosch project identifier (EPK)38/1/MDG1_MD1CP002/11/P_1289//VKWN0///Offset in the file: 0x091A58

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MD1CP002 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number O_8KWN0-00004E7B-006 and software number 10SW048033. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MD1CP002

Bosch MD1CP002 original files

The Bosch MD1CP002 unit page