Original file

Opel Crossland Bosch MD1CS003 62Q2X_PUO8B_6A6O1_9693374480 / 2227770000

An original (stock) flash read of the Bosch MD1CS003 control unit, fitted in Opel Crossland, hardware number 62Q2X_PUO8B_6A6O1_9693374480 and software number 2227770000, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Opel Crossland1.5 diesel · 130.0PS / 95.6kW
Control unit
Bosch MD1CS003
File size
2,048.00 KB
Contents
Flash
Hardware number
62Q2X_PUO8B_6A6O1_9693374480
Software number
2227770000
Bosch part / software
10SW041664
Vehicle maker's hardware number
9693374480

Technical data

Vehicle
BrandOpel
Car modelCrossland
Engine1.5 diesel
Power130.0PS / 95.6kW
Control unit
Control unitBosch MD1CS003
ECU makerBosch
Hardware number62Q2X_PUO8B_6A6O1_9693374480
Software number2227770000
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key16fc29517b6662ff
Identification read from the file
ECU nameMD1CS003
Bosch part / software10SW041664Offset in the file: 0x000144
Vehicle maker's hardware number9693374480Offset in the file: 0x000257
Software / calibration62Q2X_PUO8B_6A6O1_9693374480Offset in the file: 0x000228
Bosch project identifier (EPK)59/1/MD1CS003/014/1396//C48b/62Q2X_PUO8B_6A6O1_9693374480//Offset in the file: 0x000228

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for DPF off, EGR off, AdBlue (SCR) off, lambda off, swirl flaps off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MD1CS003 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 62Q2X_PUO8B_6A6O1_9693374480 and software number 2227770000. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MD1CS003

Bosch MD1CS003 original files

The Bosch MD1CS003 unit page