Original file

Smart Forfour Bosch ME17.9.20 0389381220 / 10SW0408191220_8D0

An original (stock) flash read of the Bosch ME17.9.20 control unit, fitted in Smart Forfour, hardware number 0389381220 and software number 10SW0408191220_8D0, 2,560.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Smart Forfour0.9 · 90.0PS / 66.2kW
Control unit
Bosch ME17.9.20
Read type
Full read (boot area included)
File
2,560.00 KB · Flash
Hardware number
0389381220
Software number
10SW0408191220_8D0
Bosch part / software
10SW038938
Software / calibration
2819027805

Technical data

Vehicle
BrandSmart
Car modelForfour
Engine0.9
FuelPetrol
Power90.0PS / 66.2kW
Control unit
Control unitBosch ME17.9.20
ECU makerBosch
Hardware number0389381220
Software number10SW0408191220_8D0
File
File typeOriginal flash read
File size2,560.00 KB (2,621,440 bytes)
File key6ac4ea02f9d7fafb
Identification read from the file
ECU nameME17.9.20
Read typeFull read (boot area included)
ProcessorTC1782
Bosch part / software10SW038938Offset in the file: 0x02001A
Software / calibration2819027805Offset in the file: 0x22A208
Data set number2819037206Offset in the file: 0x22A213
Internal build stringCB_015_TC1782_1.3.1Offset in the file: 0x00D8FB
Bosch project identifier (EPK)39/1/ME17_9_20/15/P_1220//r1780_8D0_///Offset in the file: 0x02E464

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch ME17.9.20 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number 0389381220 and software number 10SW0408191220_8D0. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch ME17.9.20

Bosch ME17.9.20 original files

The Bosch ME17.9.20 unit page