Original file

Smart ForTwo Bosch ME17.9.20 MCE2005TGLMRH20500173 / 10SW016844

An original (stock) flash read of the Bosch ME17.9.20 control unit, fitted in Smart ForTwo, hardware number MCE2005TGLMRH20500173 and software number 10SW016844, 2,560.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Smart ForTwo1.0 petrol 71PS
Control unit
Bosch ME17.9.20
Read type
Calibration only (data set)
File
2,560.00 KB · Flash
Hardware number
MCE2005TGLMRH20500173
Software number
10SW016844
Software / calibration
2819020804

Technical data

Vehicle
BrandSmart
Car modelForTwo
Engine1.0 petrol 71PS
Power71.0PS / 52.2kW
Control unit
Control unitBosch ME17.9.20
ECU makerBosch
Hardware numberMCE2005TGLMRH20500173
Software number10SW016844
File
File typeOriginal flash read
File size2,560.00 KB (2,621,440 bytes)
File keyf456bfb18cc79d1c
Identification read from the file
ECU nameME17.9.20
Read typeCalibration only (data set)
Bosch part / software10SW016844Offset in the file: 0x20001A
Software / calibration2819020804Offset in the file: 0x2299C0
Data set number2819038504Offset in the file: 0x2299CB
Bosch project identifier (EPK)39/1/ME17_9_20/15/P_1220//r1780_890_///Offset in the file: 0x226BC0

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch ME17.9.20 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MCE2005TGLMRH20500173 and software number 10SW016844. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch ME17.9.20

Bosch ME17.9.20 original files

The Bosch ME17.9.20 unit page