Original file

Smart ForTwo Bosch ME17.9.20 MCE4032TGLMRH60500173 / 1037551960

An original (stock) flash read of the Bosch ME17.9.20 control unit, fitted in Smart ForTwo, hardware number MCE4032TGLMRH60500173 and software number 1037551960, 2,688.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Smart ForTwo0.9 petrol 90PS
Control unit
Bosch ME17.9.20
Read type
Full read (boot area included)
File
2,688.00 KB · Flash
Hardware number
MCE4032TGLMRH60500173
Software number
1037551960
Bosch part / software
10SW017084
Software / calibration
2819021204

Technical data

Vehicle
BrandSmart
Car modelForTwo
Engine0.9 petrol 90PS
Power90.0PS / 66.2kW
Control unit
Control unitBosch ME17.9.20
ECU makerBosch
Hardware numberMCE4032TGLMRH60500173
Software number1037551960
File
File typeOriginal flash read
File size2,688.00 KB (2,752,512 bytes)
File keyf9503cb084c37c66
Identification read from the file
ECU nameME17.9.20
Read typeFull read (boot area included)
ProcessorTC1782
Bosch part / software10SW017084Offset in the file: 0x02001A
Software / calibration2819021204Offset in the file: 0x2299C0
Data set number2819038904Offset in the file: 0x2299CB
Internal build stringCB_015_TC1782_1.3.1Offset in the file: 0x00D8FB
Bosch project identifier (EPK)39/1/ME17_9_20/15/P_1220//r1780_890_///Offset in the file: 0x02E454

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch ME17.9.20 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number MCE4032TGLMRH60500173 and software number 1037551960. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch ME17.9.20

Bosch ME17.9.20 original files

The Bosch ME17.9.20 unit page