Original file

Smart ForTwo Bosch ME17.9.20 W0090771220 / 10SW004214

An original (stock) flash read of the Bosch ME17.9.20 control unit, fitted in Smart ForTwo, hardware number W0090771220 and software number 10SW004214, 2,560.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Smart ForTwo1.0 petrol 90PS
Control unit
Bosch ME17.9.20
Read type
Full read (boot area included)
File
2,560.00 KB · Flash
Hardware number
W0090771220
Software number
10SW004214
Software / calibration
2819023403

Technical data

Vehicle
BrandSmart
Car modelForTwo
Engine1.0 petrol 90PS
Power90.0PS / 66.2kW
Control unit
Control unitBosch ME17.9.20
ECU makerBosch
Hardware numberW0090771220
Software number10SW004214
File
File typeOriginal flash read
File size2,560.00 KB (2,621,440 bytes)
File key1eeb0ca6b3b68a19
Identification read from the file
ECU nameME17.9.20
Read typeFull read (boot area included)
ProcessorTC1782
Bosch part / software10SW004214Offset in the file: 0x02001A
Software / calibration2819023403Offset in the file: 0x2292F4
Data set number2819030204Offset in the file: 0x2292FF
Internal build stringCB_015_TC1782_1.3.1Offset in the file: 0x00D8FB
Bosch project identifier (EPK)39/1/ME17_9_20/15/P_1220//r1780_870_///Offset in the file: 0x02E3C4

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch ME17.9.20 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number W0090771220 and software number 10SW004214. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch ME17.9.20

Bosch ME17.9.20 original files

The Bosch ME17.9.20 unit page