Original file

Ford Mondeo Bosch MED17.0.1 DG9A-12B684-XB / 10SW004458

An original (stock) flash read of the Bosch MED17.0.1 control unit, fitted in Ford Mondeo, hardware number DG9A-12B684-XB and software number 10SW004458, 2,048.00 KB. The file is supplied exactly as it was read from the unit, byte for byte; nothing is changed in it.

Is this your file?

Compare these numbers with the label on your control unit before you order.

Vehicle
Ford Mondeo1.5 petrol 160PS
Control unit
Bosch MED17.0.1
Read type
Full read (boot area included)
File
2,048.00 KB · Flash
Hardware number
DG9A-12B684-XB
Software number
10SW004458
Vehicle maker's hardware number
FS7A-12A650-BSF

Technical data

Vehicle
BrandFord
Car modelMondeo
Engine1.5 petrol 160PS
Power160.0PS / 117.7kW
Control unit
Control unitBosch MED17.0.1
ECU makerBosch
Hardware numberDG9A-12B684-XB
Software number10SW004458
File
File typeOriginal flash read
File size2,048.00 KB (2,097,152 bytes)
File key228d972ba3f17ed1
Identification read from the file
ECU nameMED17.0.1
Read typeFull read (boot area included)
ProcessorTC1767
Bosch part / software10SW004458Offset in the file: 0x00401A
Vehicle maker's hardware numberFS7A-12A650-BSFOffset in the file: 0x00FC30
Software / calibrationDG9A-12B684-XBOffset in the file: 0x00FC00
Engine descriptionFS7A-14C204-BSGOffset in the file: 0x1FFF4B
Internal build stringMED170_PBL_67_T3_DG506_1Offset in the file: 0x00FA58
Bosch project identifier (EPK)44/1/MED17/22/MEDECM//D1701_021_0500/Dst00//Offset in the file: 0x07FF08

About this file

Typical uses: restoring a control unit to its factory software after a failed flash or a corrupt memory, a clean base before any change, comparing a read of your own with the original. The checksum is the one of the read; your programmer or the CARTESIAN app corrects it after a change.

In CARTESIAN this original file is the base for lambda off, EGR off, flaps off, start/stop off and DTC off, each saved with a correct checksum, and for returning a modified unit to stock.

How to use this file

  1. Order with your e-mail address; the download link comes right after the payment and is valid for 30 days.
  2. Open the file in your programmer, compare its numbers with your unit and check the checksum.
  3. Write it only to a Bosch MED17.0.1 whose label carries the same hardware and software numbers.

Before you write Compare the numbers on your control unit with this file, hardware number DG9A-12B684-XB and software number 10SW004458. A file written to a unit with other numbers can damage it. Not sure? Search with your own read on the Database page: it is compared by content.

Other pairs of Bosch MED17.0.1

Bosch MED17.0.1 original files

The Bosch MED17.0.1 unit page